Copper doors in general natural conditions, to achieve the desired effect, it takes a long time, after the study found that if necessary, can use the chemical passivation principle can be in a very short period of time to produce the desired effect.
1. Close: General decoration words if the reception is not good, then the quality of this product will not be too good. The end is able to determine the service life of a commodity and corrosion resistance, reasonable closing is able to match other ornaments.
2. Node: The effect of the node is to enhance the appearance of the considerable, and the strength of the product.
3. Transition: In order to make the copper door produce a certain sense of three-dimensional words, the transition will be mediocre surface to get good results.
These three points in the same door processing process are reflected, high-quality raw materials and excellent process of processing out of the quality will be the best. The most important point is that there is no blunted process.
After these followed by the installation, during the installation process is not advised not to appear signs of surface wear. Without damage, the copper door can be used for more than 10 years. But with the slow passage of time will also appear aging phenomenon, this time the copper door is already the appearance of oxide film, protecting the copper door from erosion, will not affect the overall effect of the copper door.
Therefore, after the blunttreatment of the copper door, it can not only improve the service life of the copper door, but also improve the aesthetic appearance of the copper door surface.
