-
The interior of the medical door has a good cut-off effect, such as cool, noise, gas flow and electromagnetic radiation. What are the characteristics of attracting people's attention? It is well known that it is still in the private residential site. It has high rejection to door body, door frame material, container material at joint and door body production technology. Guarantee its service life and effect, such as anti electromagnetic radiation mercury plate door is usually more than 200kg.
2. The medical door should be driven by push-pull ward door rejection. There should be a strong power system in the medical door, and it should be able to restart normally on the abnormal track. In order to put forward a higher rejection of the reliability of the medical sliding door, such as safe contamination facilities, not only need to help the safety policy, such as making accurate and clear provisions on the power system properties inside the door.
3. Medical sliding door for the site factors, but also have a positive and reliable medical door. Such as collection, secondary feeling, electrified lock and so on, these basic functions cannot be lacked.
4. The basic functions of the internal control part of the medical door are rejected completely.
5. The sensors accepted in the medical door are more abnormal, and there are different basic principles of feeling, which make the active medical sliding door have equal comfort in use, such as close distance non-contact left hand feeling, foot feeling and sensor with key.
The special door of medical hospital is limited to area and performance.
1, The sealing inside the door is rejected:
1. The current area limited by electric control part should not be long area. However, the cost is high, and stainless steel plate is used as the outer layer.
2. Door body, electrolytic aluminum alloy color steel plate and other stainless steel plates are the best. The interlayer of both sides should be clamped with lead plate of certain width. The sandwich of both sides should be made of plastic technology or honeycomb structure to resist electromagnetic radiation. Other exterior wall joints should be octagonal. Guard against interference with health care products.
3. The electric control part must be in accordance with the state's international standards on electromagnetic compatibility.
4. Transmission gear reducer should not be specially designed to minimize noise so as to meet the rejection of noise in the clean room.
2, Abnormal rejection of performance: such as non touch manual sensor or head sensor
1. Non contact proximity sensors must be provided.
2. There must be the basic function of closing with time delay and the basic function of twice feeling.
3. Make sure there is a spare battery connected module.
4. There must be a performance module to restart the shower electronics.
5. Strengthen the anti pinch function to improve the reliability, and the door body must be equipped with the capability of arresting and returning ammunition.
